High voltage hand-held insulation and continuity tester

  •   Insulation testing up to 2.5 kV  and 200 GΩ range in a hand held instrument
  •   Guard terminal for high resistance accuracy
  •   Adjustable insulation test voltage from 50 V to 2500 V
  •   Stabilized insulation test voltage
  •   Rechargeable options for mains and car charging
  •   Single range, faster continuity testing from 0.01 Ω to 1 MΩ
  •   Polarization Index (PI) & Dielectric Absorption Ratio (DAR)
  •   CAT IV 600 V applications
  •   Polarization Index (PI) & Dielectric Absorption Ratio (DAR)
  •   CAT IV 600 V applications

The MIT2500 insulation and continuity tester has been designed for motor and cable testing, specialist applications and electrical testing applications, where operation voltages  exceed 1000 V and higher insulation test voltages are needed.

The MIT2500 offers both fixed range voltages of 50 V, 100V, 250 V, 500 V, 1000 V and 2500 V, as well as a variable range that allows any voltage between 50 V and 2500 V to be “dialed in”. This is supported by the new test voltage feedback control, which maintains the output test voltage to within 2% of the selected range, even when under test.

Product Documents
Quick start
MIT400/2 & MIT2500
Technical Documents
Megger device drivers

USB drivers for a range of Megger products

Megger Downloader

Software to download test results from MIT330, MIT430, MIT485, MIT400-2 and MIT2500 test instruments.

*Please note* - Software installation may be blocked by Windows Defender SmartScreen. See instructions below to allow install:

1. Navigate to the 'MeggerDownloaderSetup.msi' file, right click and choose 'Properties'.

2. Click the checkbox next to 'Unblock'.

3. Click 'Apply' and 'Ok'.

4. The install file should now run.

Megger Downloader
436.0 KB | 04/07/22