Menu
Support
Technical library

Technical library

The Megger technical library provides access to a range of additional content and resources such as technical guides, application notes and more. Use the filters to browse specific content (e.g. application notes) or refine your search to a particular electrical application area. 

 

If you would like to see the content we have available on a particular subject or need to locate some software, simply enter a search below. Please note, you will need to create an account to access some resources.

Filter by application type:
    Showing item(s) 11 - 20 of 303 in total
SVERKER
Software download files for SVERKER900
Published: 17 May 2019
Download
TTRU3 - 1 phase v/s 3 phase
   
Published: 16 May 2019
Download PDF
TTRU3 - Magnetic Balance
  
Published: 16 May 2019
Download PDF
SVERKER900 - Testing-ROCOF-protection
Rate Of Change Of Frequency (ROCOF) protection is used in distributed or embedded generation schemes, where a local generator is connected directly to the distribution network, as specified in national standards such as Ansi 81R or G59/3
Published: 15 May 2019
Download PDF
SVERKER900 - Testing ABB Trip Circuit Supervision relay
Check trip on relay with ABB supervision relay
Published: 15 May 2019
Download PDF
SVERKER900 - Testing impedance based protection
The impedance measurement schemes are widely used for protection of different assets within electric power systems. Relay protection devices utilizing such schemes are benefiting from continuous monitoring of both voltage and current quantities within the protected circuit and the calculated impedance value is employed to determine whether the circuit is operating in a normal condition or not.
Published: 15 May 2019
Download PDF
SVERKER900 - Testing negative sequence overcurrent protection
Unbalance phase currents in a power system that exceed the allowable normal operation limit can indicate abnormal condition or even existence of fault(s) in the system. The operating principal unbalance over current protection is normally based on measurement of negative sequence component of unbalance phase currents. Similar to phase over current protection, normally a pick up (start) threshold and a definite time delay for operation can be set.
Published: 15 May 2019
Download PDF
SVERKER900 Demo Testing
To be used as demonstration/course material
Published: 15 May 2019
Download PDF
SVERKER900 - Testing directional earth fault
Directional earth fault protection are commonly used to protect long outgoing feeders from tripping because of fault on other outgoing lines.
Published: 15 May 2019
Download PDF
  • <
  • 1
  • 2
  • 3
  • 4
  • 5
  • ...
  • >
  • Showing item(s) 11 - 20 of 303 in total