Menu
Support
Technical library

Technical library

The Megger technical library provides access to a range of additional content and resources such as technical guides, application notes and more. Use the filters to browse specific content (e.g. application notes) or refine your search to a particular electrical application area. 

 

If you would like to see the content we have available on a particular subject or need to locate some software, simply enter a search below. Please note, you will need to create an account to access some resources.

Filter by application type:
    Showing item(s) 81 - 90 of 214 in total
Fast Transients
Very fast transients have limited energy due to their short duration. They are caused by arcing faults, such as bad brushes in motors, and are rapidly damped out by even a few meters of distribution wiring.
Published: 7 December 2018
Download PDF
Pumping Station Motor Analysis
This test was performed at a pumping station that was using multiple 600HP motors and a VFD drive. The reported problem was the plant was not receiving adequate power output from the motors during peak times. It was not possible to connect to the inputs of the motors themselves so an MPQ2000 was connected to the output of the VFD and the following measurements were recorded.
Published: 7 December 2018
Download PDF
MPQ1000 Common Connections
An application note locoking at the common connections of the MPQ1000.
Published: 7 December 2018
Download PDF
Merging MPQ Data Files
Adding, removing or changing a piece of equipment in a facility can have significant impacts on the power quality and energy requirements. Introduced power quality phenomenon can cause equipment to trip off line. This can represent significant losses in revenue. Added equipment can create high peak loads or increased reactive currents that can lead to penalties. In order to determine the impact of these changes a power quality and demand study should be performed prior to the change and after the change.
Published: 7 December 2018
Download PDF
Rapid Voltage Change (RVC)
A rapid voltage change is a fast rise or fall of the RMS voltage. This can be caused by the switching on of a specific load or by a sudden change in source voltage. Sudden source voltage changes can occur in solar grids when the sun is obscured by clouds. Source voltage changes can also occur in wind farms when then wind speed decreases. Load switching can cause a rapid voltage change if the rating of the load is a significant fraction of the fault level of the supply voltage.
Published: 7 December 2018
Download PDF
Enabling Additional Channels
When creating a setup file a particular power wiring connection needs to be selected. This instructs the instrument on how to calculate the power and energy. When the power wiring connection is create the required input channels are automatically enabled.In some cases the operator may wish to enable additional channels for other measurements. This will not affect the power or energy measurements.
Published: 6 December 2018
Download PDF
Mains Signaling
Power-line communication (PLC) carries data on a conductor that is also used simultaneously for AC electric power transmission or electric power distribution to consumers. It is also known as power-line carrier, power-line digital subscriber line (PDSL), mains communication, power-line telecommunications, or power-line networking (PLN).
Published: 6 December 2018
Download PDF
Renaming test files on the MPQ units
An application note explaining how to rename test files on the MPQ test units. This feature can be used to keep track of recordings if the user has to record on multiple locations before downloading the data to a computer.
Published: 7 November 2018
Download PDF
Measuring current on a CT secondary circuit
In some cases, measuring actual current on the primary conductor is not possible and the user may have to measure current on the secondary circuit of a CT. In this case, the MPQ can be programmed to display the actual primary current values instead of the current measured on the CT secondary circuit. This is done by following the steps given below.
Published: 6 November 2018
Download PDF
Scheduled run - MPQ series of power quality analysers
The MPQ Series of Power Quality Analysers can be programmed to start and stop recording at specific times. This type of test is called a scheduled run.
Published: 6 November 2018
Download PDF