Menu

Teleflex VX

Teleflex VX - Reflectometer

  • Bright and large display
  • Easiest operation via self guiding and explaining menus
  • ARM Multishot technology
  • Automatic storage of all results
  • Supports all existing prelocation technologies
  • Automatic detection and display of cable end and fault position

The Teleflex VX presents the latest development of the Teleflex series. Like all Teleflex reflectometers, the Teleflex VX is specially designed to capture the fast processes during the fault location in power cables. It presents the consequent continuation of the Linux based Teleflex MX

The operation is reduced to the essential steps, and runs mostly automatically. The completely new hardware of the Teleflex VX with significantly improved parameters, as for example sampling frequency, pulse width and pulse amplitude results in ranges of up to 1000 km, but also in highest resolution in the close range.

Measuring hardware and display are separated, and communicate via Ethernet. This allows the easy integration into a fault location system and allows the operation in offshore application, for example, the remote operation in ROV’s.

Technical Documents
Technical guide
MeggerBook Cable Brochure
MeggerBook Cable & MeggerBook Report Edition
MeggerBook Cable & MeggerBook Report Edition Software
 
The setup file below is suitable for the installation of both MeggerBook Cable (full version) and MeggerBook Report Edition (free limited version).
 
When started with a suitable license dongle plugged into the installation PC, the software starts as MeggerBook Cable which allows for easy and comprehensive data evaluation, data archiving, cable management and report creation. A personal quotation for a certain number of licenses can be requested here .
 
Without the required dongle the software starts as MeggerBook Report Edition which allows for seamless report creation and offers the same features as the full version while limiting the data storage options as follows:
 

•  Measurements, analyses and reports are not permanently stored in the database

•  While cable import and storage are not limited, a maximum of 5 cables can be created using the cable editor  of the Report Edition

 

At this time, the software can handle the measurement and test data of the following Megger devices:

 

Test vans:            Centrix, Centrix City, Compact City, R30, Variant

Test systems:     VLF Sine Wave 45 / 62, VLF CR 40/60, TDS 40/60

TDRs:                     Teleflex VX(-P), Teleflex SX

 

Note for test systems VLF Sine Wave 45 and VLF Sine Wave 62:

 

Data of these test systems can only be imported into the software, if the test systems is equipped with firmware version 3.14 or higher. The latest firmware can be found here (VLF Sine Wave 45) and here (VLF Sine Wave 62).

 

Setup-MeggerBook-2-4-7.zip
57.0 MB | 19/11/19
MeggerBook Report Edition Quick Guide
Quick_Guide_Report_Edition.pdf
809.3 KB | 19/11/19